Kia Stinger: Tires and wheels / Checking tire inflation pressure

Kia Stinger CK 2018-2025 Owners Manual / Maintenance / Tires and wheels / Checking tire inflation pressure

Check your tires once a month or more.

Also, check the tire pressure of the spare tire.

How to check

Use a good quality gauge to check tire pressure. You can not tell if your tires are properly inflated simply by looking at them. Radial tires may look properly inflated even when they're underinflated.

Check the tire's inflation pressure when the tires are cold. - "Cold" means your vehicle has been sitting for at least three hours or driven no more than 1.6 km (1 mile).

Remove the valve cap from the tire valve stem. Press the tire gauge firmly onto the valve to get a pressure measurement. If the cold tire inflation pressure matches the recommended pressure on the tire and loading information label, no further adjustment is necessary. If the pressure is low, add air until you reach the recommended amount.

If you overfill the tire, release air by pushing on the metal stem in the center of the tire valve. Recheck the tire pressure with the tire gauge. Be sure to put the valve caps back on the valve stems. They help prevent leaks by keeping out dirt and moisture.

Tire pressure
Always observe the following: Check tire pressure when the tires are cold. (After vehicle has been parked for at least three hours or hasn't been driven more than 1.6 km (one mile) since sta ...

Tire rotation
To equalize tread wear, it is recommended that the tires be rotated every 10,000 km (6,000 miles) or sooner if irregular wear develops. During rotation, check the tires for correct balance. When r ...

Other information:

Kia Stinger CK 2018-2025 Service Manual: ECS-G Sensor


Repair procedures Removal [Body G Sensor] Front 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove wheel nuts, wheel and tire (A) from hub. Tightening torque: 107.9 - 127 ...

Kia Stinger CK 2018-2025 Owners Manual: Closing the fuel filler lid


1. To install the cap, turn it clockwise until it “clicks” once. This indicates that the cap is securely tightened. 2. Close the fuel filler lid and push it in lightly making sure that it is securely closed. ✽ NOTICE There may be an intermittent noise near the refueling hole while the e ...

Copyright © www.kstinger.com 2015-2025