Kia Stinger: Emission Control System / Crankcase Emission Control System

Kia Stinger CK 2018-2025 Service Manual / Emission Control System / Crankcase Emission Control System

Schematic diagrams
Schematic Diagram

Repair procedures
Inspection
1.

After disconnecting the vapor hose from the PCV valve, remove the PCV valve.

2.

Reconnect the PCV valve to the vapor hose.

3.

Run the engine at idle, then put a finger over the open end of the PCV valve and make sure that intake manifold vacuum can be felt.

  

The plunger inside the PCV valve will move back and forth in vacuum.

4.

If vacuum could not be felt, inspect the PCV operation. If operating correctly, clean or replace the vapor hose.

Specifications
Service data Service Data Purge Control Solenoid Valve (PCSV) ▷ Specification Item Specification Coil Resistance (Ω) 18.5 - ...

Positive Crankcase Ventilation (PCV) Valve
Description and operation Operation Principle Repair procedures Removal 1. Disconnect the PCV hose (A). 2. Remove the PCV valve ...

Other information:

Kia Stinger CK 2018-2025 Service Manual: Rear Door Belt Outside Weatherstrip


Repair procedures Replacement 1. Pull down rear door window glass by pressing the power window glass switch. 2. Remove the rear door belt outside weatherstrip (A). 3. Install in the reverse order of removal. ...

Kia Stinger CK 2018-2025 Service Manual: Propeller Shaft


Repair procedures Inspection CV Joint and boots 1. Shift the transmission lever to Neutral. 2. Raise the vehicle off the ground, and support it with safety stands in the proper locations. 3. Check the center bearing (A) ...

Copyright © www.kstinger.com 2015-2025