Kia Stinger CK: ISG (Idle Stop and Go) system / Auto stop

Kia Stinger (CK) 2018-2023 Owner's Manual / Driving your vehicle / ISG (Idle Stop and Go) system / Auto stop

Contents:

To stop the engine in idle stop mode

Stop the vehicle completely by pressing the brake pedal when the shift lever is in the D (Drive) or N (Neutral) position.

The engine will stop and the green AUTO STOP( ) indicator on the instrument cluster will illuminate.

✽ NOTICE

If you open the engine hood in auto stop mode, the following will happen:

  • The ISG system will deactivate (the light on the ISG OFF button will illuminate).
  • A message will appear on the LCD display.

  • If you move the transmission lever from N to D (manual mode) or R without depressing the brake pedal after stopping engine automatically, the engine does not restart automatically and a warning chime alarms. When this happens, press the brake pedal for auto start.

ISG (Idle Stop and Go) system

Auto start

Other information:

Kia Stinger (CK) 2018-2023 Owner's Manual: Electric Waste Gate Actuator (EWGA)

Description and operation Desrcription Installed on the turbocharger, the Electric Waste Gate Actuator (EWGA) operates the vane in the Waste Gate Turbocharger (WGT) and regulates the compressed air amount based on the PWM signal from the ECM. This actuator consists of a DC motor which actuates the vane, a 2-step gear which increases torque of the DC motor, a position sensor which detects status of the vane, and an electric control unit which drives the DC motor.

Kia Stinger (CK) 2018-2023 Owner's Manual: Rear Door Inside Handle

Repair procedures Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Rremove the rear door inside handle (A) after loosening mounting screws. 3. Install in the reverse order of removal.    • Make sure that the door locks/unlocks and opens/closes properly.

Categories

 
Copyright © 2026 www.kstinger.com 0.0112