Kia Stinger CK: Driving your vehicle / Automatic transmission

Kia Stinger (CK) 2018-2023 Owner's Manual / Driving your vehicle / Automatic transmission

Contents:

Automatic transmission operation ➤

Good driving practices

Never move the gear shift lever from P (Park) to any other position with the accelerator pedal depressed.
Never move the gear shift lever into P (Park) when the vehicle is in motion.
Slow down before shifting to a lower gear. Otherwise, the lower gear may not be engaged.
Always use the parking brake. Do not depend on placing the transmission in P (Park) to keep the vehicle from moving.
Optimum vehicle performance and economy is obtained by smoothly depressing and releasing the accelerator pedal.

✽ NOTICE - Kickdown Mechanism

Use the kickdown mechanism for maximum acceleration. Depress the accelerator pedal beyond the pressure point. The automatic transmission will shift to a lower gear depending on the engine speed.

Moving up a steep grade from a standing start

To move up a steep grade from a standing start, depress the brake pedal, release the parking brake, and shift the shift lever to D (Drive). Depress the accelerator gradually while releasing the brake pedal.

Launch Control ➤

Starting the engine with a smart key

Automatic transmission operation

Other information:

Kia Stinger (CK) 2018-2023 Owner's Manual: When the lane ahead is clear

The vehicle speed will maintain the set speed. When there is a vehicle ahead of you in your lane The vehicle will maintain the set speed, when the lane ahead is clear. The vehicle will slow down or speed up within selected speed to maintain the selected distance, when there is a vehicle ahead of you in the lane. (A vehicle will appear in front of your vehicle in the LCD display only when there is an actual vehicle in front of you) If the vehicle ahead speeds up, your vehicle will travel at a steady cruising speed after accelerating to the selected speed.

Kia Stinger (CK) 2018-2023 Owner's Manual: Headlamp (Low/High beam) bulb replacement (Headlamp Type A)

■ Head lamp - Type A 1. Remove the service cover clip on the wheel housing. 2. Remove the headlamp bulb cover by turning it counterclockwise. 3. Disconnect the headlamp bulb socket-connector. 4. Remove the bulb-socket from the headlamp assembly by turning the bulb-socket counterclockwise until the tabs on the bulb-socket align with the slots on the headlamp assembly.