Contents:
WARNING - Windshield heating
Do not use the
or
position during cooling operation
in extremely humid weather. The difference between the temperature of the outside
air and the windshield could cause the outer surface of the windshield to fog up,
causing loss of visibility. In this case, set the mode selection to the
position and fan speed control to
the lower speed.
The system automatically selects the outside (fresh) air position when the climate control system operates over a certain period of time (approximately 30 minutes) in low temperature with the recirculated air position selected.
To cancel or reset the Automatic Ventilation
When the air conditioning system is on, select Face Level
mode and while pressing the A/C button,
press the recirculated air position button five times within three seconds.
When the automatic ventilation is canceled, the indicator blinks 3 times. When the automatic ventilation is activated, the indicator blinks 6 times.
If the battery is discharged or detached, the automatic ventilation will be reset. Adjust the feature accordingly.
The smart ventilation system maintains pleasant/fresh air condition inside the passenger compartment by automatically detecting/controlling the temperature and humidity when you drive the vehicle with the climate control system in the OFF position. When the smart ventilation system starts to operate, the message, “SMART VENTILATION ON” appears for 5 seconds.
Kia Stinger (CK) 2018-2023 Owner's Manual: Rear Glass Defogger Printed Heater
Repair procedures Inspection • Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply pressure on the tin foil with hand and move the tin foil along the grid line to check for open circuits.Components and components location Components 1. E-Shifter 2. Parking release actuator 3. Parking release cable 4. Parking release lever Schematic diagrams Circuit Diagram Description and operation Description • Operating Principle: Any change in the lever position is detected and transmitted via electric signals from the electronic shift lever ECU to the TCM.