Kia Stinger: Automatic Transmission Control System / Shift Lever

Kia Stinger CK 2018-2025 Service Manual / Automatic Transmission System / Automatic Transmission Control System / Shift Lever

Components and components location
Components

1. Manual control lever
2. Shift cable
3. Shift lever assembly
4. Knob

Repair procedures
Removal
1.

Shift the gear to "N".

2.

Remove the knob (A) by pulling it in the direction of arrow after removing the boots from the console upper cover.

3.

Remove the floor console assembly.

(Refer to Body - “Floor Console Assembly”)

4.

Disconnect the shift lever main connector.

5.

Remove the shift lever (A) after loosening the mounting bolts.

Tightening torque :

8.8 - 13.7 N·m (0.9 - 1.4 kgf·m, 6.5 - 10.1 lb·ft)

6.

Remove the snap pin (A) and shift cable fixing clip (B).

7.

Remove the shift cable from the shift lever after loosening the screws (A).

Tightening torque :

0.69 - 1.37 N·m (0.07 - 0.14 kgf·m, 0.51 - 1.01 lb·ft, 6.08 - 12.15 lb·in)

Installation
1.

Install in the reverse order of removal.

Inhibitor Switch
Specifications Specifications Item Specification Output type PWM Power supply (V) 5 Comp ...

Shift Cable
Components and components location Components 1. Manual control lever 2. Shift cable 3. Shift lever assembly 4. Knob Repair procedures R ...

Other information:

Kia Stinger CK 2018-2025 Service Manual: Overhead Console Lamp


Repair procedures Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. Removal 1. Disconnect ...

Kia Stinger CK 2018-2025 Service Manual: Front Bumper


Components and components location Components 1. Front bumper cover assembly 2. Front bumper mounting bracket 3. Front bumper side bracket ...

Copyright © www.kstinger.com 2015-2025