Kia Stinger: Airbag Module / Side Airbag (SAB) Module
Description and operation
Installed inside the front seat, the side airbags (SAB) protect the driver and
front passenger from danger in the event of a side crash. The SRSCM determines deployment
of side airbag based on Side Impact Sensor (SIS) signal.
Never attempt to measure the circuit resistance of the airbag module
(squib) even if you are using the specified tester. If the circuit resistance
is measured with a tester, accidental airbag deployment will result in serious
personal injury
|
Components and components location
Repair procedures
1. |
Disconnect the battery negative terminal.
After disconnecting the cables, wait at least 30 seconds.
|
|
2. |
Remove the seat back cover.
(Refer to Body -"Front seat back cover")
Improper mounting of the front seat back cover, so interfering
with the normal deployment of side airbags and front seat backrest
ensure that the cover is well seated.
|
|
3. |
Loosen the side airbag module nuts and then remove the airbag module
(A).
Tightening torque :
6.0 - 8.0 N.m (0.6 - 0.8 kgf.m, 4.4 - 5.9 lb-ft)
|
|
4. |
Install in the reverse order of removal.
|
Description and operation
Description
Installed inside the crash pad, the passenger airbag (PAB) protects the front
passenger in the event of a frontal crash. The SRSCM determines if a ...
Description and operation
Description
Installed inside the headliner, the curtain airbags (CAB) protect the driver
and passengers from danger in the eThe SRSCM determines deployment of ...
Other information:
The power steering uses a motor to assist you in steering the vehicle. If the
engine is off or if the power steering system becomes inoperative, the vehicle may
still be steered, but it will require increased steering effort.
The EPS is controlled by a power steering control unit which senses t ...
Repair procedures
Refilling And Bleeding
Never remove the radiator cap when the engine is hot. Serious scalding
could be caused by hot fluid under high pressure escaping from the radiator.
...