Kia Stinger CK: Automatic transmission (shift-by-wire) / Launch Control

Contents:

Launch Control Operation

  • When using Launch Control, a driver should always make sure that the engine’s cooling water is warmed up and reaches a recommended temperature.
  • To operate ESC Off state 2, Press and hold ESC button for more than 3 seconds in Sports mode. (Status Display on Cluster Screen)
  • For launching, stop the vehicle and keep the steering wheel straight.
  • Footbrakes, EPB and Auto Hold must be released for smooth launching.

  • Press the brake firmly with your left foot in transmission D mode, while pressing the accelerator pedal down fully with your right foot. Then, the Launch Control Ready (1) will be in place.

  • To start a vehicle, with your right foot pressing the accelerator pedal down fully, remove your left foot from the brake. (within 4 seconds) (Launch Control Active (2) Status Display on Cluster Screen)
  • If both the brakes and accelerater pedals were applied and the driver removes his foot only from the accelerater pedal, Launch Control will be automatically deactivated. Or, if the vehicle does not start after 4 seconds with a driver’s feet on both brake and accelerate pedals, Launch Control will automatically deactivated as well.
  • Do not operate both brake and accelerate pedals simultaneously for longer than 4 seconds.
  • When re-using Launch Control, a driver should have the vehicle cool down sufficiently by driving.

Limited use of Launch Control (3)

  • An warning message will pop up on the screen if the transmission fluid temperature is above a certain level while using Launch Control. Also, Launch Control will be automatically deactivated.
  • To address the issue as above, a driver should cool down the transmission fluid temperature by driving the vehicle. (Driving at a constant speed over 60 km/h (37 mph) is highly recommended, but this should only be done if traffic and road conditions permit the driver to do so safely.)

WARNING

It is the responsibility of the driver to make sure it is safe before using Launch Control. Do not use Launch Control on public roads or when pedestrian congestion is present. Doing so could result in an accident that causes serious injuries.

✽ NOTICE

Launch performance can vary depending on fuel, environment, tire, and loading conditions.

CAUTION

Constant use of Launch Control can put enormous stress on transmission, engine, and drive shafts and can result in vehicle damage. It is highly recommended that Launch Control is used after completion of the vehicle brake-in process.

Other information:

Kia Stinger (CK) 2018-2023 Owner's Manual: CVVT (Continuous Variable Valve Timing) System

Description and operation Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load. By controlling CVVT, the valve over-lap or under-lap occurs, which makes better fuel economy and reduces exhaust gases (NOx, HC) and improves engine performance through reduction of pumping loss, internal EGR effect, improvement of combustion stability, improvement of volumetric efficiency, and increase of expansion work.

Kia Stinger (CK) 2018-2023 Owner's Manual: Pre-tensioner seat belt

Your vehicle is equipped with driver's and front passenger's pre-tensioner seat belts (retractor pretensioner and EFD (Emergency Fastening Device)). The pre-tensioner seat belts may be activated, when a frontal collision is severe enough, together with the air bags. When the vehicle stops suddenly, or if the occupant tries to lean forward too quickly, the seat belt retractor may lock into position.

Categories

 
Copyright © 2026 www.kstinger.com 0.0117