Kia Stinger CK: Child Restraint System (CRS) / Installing a Child Restraint System (CRS)

Kia Stinger (CK) 2018-2023 Owner's Manual / Safety features of your vehicle / Child Restraint System (CRS) / Installing a Child Restraint System (CRS)

Contents:

After selecting a proper child seat for your child, check to make sure it fits properly in your vehicle. Follow the instructions provided by the manufacturer when installing the child seat. Note these general steps when installing the seat to your vehicle:

Properly secure the child restraint to the vehicle. All child restraints must be secured to the vehicle with the lap part of a lap/shoulder belt or with the LATCH system.
Make sure the child restraint is firmly secured. After installing a child restraint to the vehicle, push and pull the seat forward and from side-to-side to verify that it is securely attached to the seat. A child restraint secured with a seat belt should be installed as firmly as possible. However, some side-toside movement can be expected.
Secure the child in the child restraint. Make sure the child is properly strapped in the child restraint according to the manufacturer instructions.

Lower Anchors and Tether for Children (LATCH) System ➤

Securing a child restraint with the LATCH anchors system

To install a LATCH-compatible child restraint in either of the rear outboard seating positions:

1. Move the seat belt buckle away from the lower anchors.

2. Move any other objects away from the anchors that could prevent a secure connection between the child restraint and the lower anchors.

3. Place the child restraint on the vehicle seat, then attach the seat to the lower anchors according to the instructions provided by the child restraint manufacturer.

4. Follow the child restraint instructions for properly adjusting and tightening the lower attachments on the child restraint to the lower anchors.

WARNING

Take the following precautions when using the LATCH system:

Read and follow all installation instructions provided with your child restraint system.
To prevent the child from reaching and taking hold of the unused seat belts, buckle all unused rear seat belts before the child is placed into the vehicle. Lock each unused seat belt following the instructions in the "Automatic locking mode" subsection, and place the webbing behind the child seat or against an unused seat back. Children can be strangled if a shoulder belt becomes wrapped around their neck and the seat belt tightens. • NEVER attach more than one child restraint to a single anchor. This could cause the anchor or attachment to come loose or break.
Always have the LATCH system inspected by your authorized Kia dealer after an accident. An accident can damage the LATCH system and may not properly secure the child restraint.

Securing a child restraint seat with “Tether Anchor” system ➤

Securing a child restraint with a lap/shoulder belt ➤

Selecting a Child Restraint System (CRS)

Lower Anchors and Tether for Children (LATCH) System

Other information:

Kia Stinger (CK) 2018-2023 Owner's Manual: Air Cleaner

Components and components location Components 1. Air cleaner assembly 2. Air intake hose 3. Air cleaner adapter 4. Air duct Repair procedures Removal and Installation 1. Remove the engine cover. (Refer to Engine and Transmission Assembly - "Engine Cover") 2.

Kia Stinger (CK) 2018-2023 Owner's Manual: Changing a tire with TPMS

If you have a flat tire, the Low Tire Pressure telltale will come on. Have the flat tire repaired by an authorized Kia dealer as soon as possible or replace the flat tire with the spare tire. CAUTION - Repair Agents Never use a puncture-repairing agent not approved by Kia to repair and/or inflate a low pressure tire. The sealant not approved by Kia may damage the tire pressure sensor.