Kia Stinger: Tires/Wheels / Wheel

Kia Stinger CK 2018-2025 Service Manual / Suspension System / Tires/Wheels / Wheel

Repair procedures

Hub nut tightening sequence

Tighten the hub nuts as follows.

Tightening torque:

107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)

When using an impact gun, final tightening torque should be checked using a torque wrench.

Run out inspection

1.	Jack up the vehicle.

Measure the wheel run-out by using a dial indicator as shown below.

Run-out	Aluminum
Radial mm (in.)	Below 0.3 (0.0118)
Lateral mm (in.)	Below 0.3 (0.0118)

3.	If measured value exceeds the standard value, replace the wheel.

Tire

Repair procedures Tire Wear • Using tires and wheels other than the recommended sizes can c ...

Alignment

Repair procedures Front wheel alignment When using a commercially available computerized wheel alignment equipment ...

Other information:

Kia Stinger CK 2018-2025 Service Manual: Blind-Spot Collision Warning (BCW) Unit

Components and components location Components Repair procedures Removal lf replacement of the bracket or extension wire of BCW unit is required, it is recommended to surely replace the defective ...

Kia Stinger CK 2018-2025 Service Manual: Cylinder Block

Repair procedures Disassembly In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t ...