Kia Stinger: Air Conditioning System / A/C Pressure Transducer
Description and operation
| Description |
A/C pressure transducer measures the pressure in high pressure line and converts it into voltage. Based on the converted voltage, engine ECU controls cooling fan by operating it at high or low speed. Engine ECU stops the operation of compressor when the temperature of refrigerant line is too high or low irregularly to optimize air conditioning system.
Repair procedures
| Inspection |
| 1. |
Measure the pressure of high pressure line by measuring voltage output between terminals “1” and “2”.
|
| 2. |
Check if the voltage is within specification.
|
| 3. |
If the measured voltage is not wihtin specification, replace the A/C pressure transducer.
|
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Recover the refrigerant with a recovery/charging station. |
| 3. |
Disconnect the A/C pressure transducer connector (A). |
| 4. |
Remove the A/C pressure transducer (B).
|
| 5. |
Install in the reverse order of removal.
|
Receiver-Drier
Repair procedures
Replacement
1.
Remove the condenser.
2.
Remove the cap (B) from the bottom of the condenser using an L wrench
(A).
...
Evaporator Core
Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater unit.
(Refer to Heater - "Heater Unit&qu ...
Other information:
Kia Stinger CK 2018-2024 Owners Manual: To decrease the cruising speed
Follow either of these procedures: Move the lever down (to SET-) and hold it. Your vehicle will gradually slow down. Release the lever at the speed you want to maintain. Move the lever down (to SET-) and release it immediately. The cruising speed will decrease by 1 km/h (1.0 mph) each ...
Kia Stinger CK 2018-2024 Owners Manual: Washer fluid
Checking the washer fluid level The reservoir is translucent so that you can check the level with a quick visual inspection. Check the fluid level in the washer fluid reservoir and add fluid if necessary. Plain water may be used if washer fluid is not available. However, use washer solvent ...
