Kia Stinger: Engine Control System / Ambient Temperature Sensor (ATS)
Specifications
| Specification |
|
Temperature[⁰C(⁰F)] |
Resistance(kΩ) |
|
-40(-40) |
811.1 - 956.8 |
|
-20(-4) |
255.6 - 287.7 |
|
0(32) |
91.5 - 98.8 |
|
20(68) |
36.6 - 38.0 |
|
30(86) |
23.8 - 24.7 |
|
40(104) |
15.7 - 16.6 |
|
50(122) |
10.6 - 11.3 |
|
60(140) |
7.2 - 7.9 |
|
80(176) |
3.6 - 4.0 |
Description and operation
| Description |
Installed on the front-end module, the Ambient Temperature Sensor (ATS) senses the ambient temperature. ECM receives the intake air temperature and ambient air temperature at the same time to precisely control the intake air quantity supplied through the turbocharger. The electrical resistance of the thermistor decreases as the temperature increases, and vice versa. This sensor has a Negative Temperature Coefficient (NTC) and its resistance is in inverse proportion to the temperature.
Schematic diagrams
| Circuit Diagram |
| Auto A/C |
| Manual A/C |
Harness Connector
Repair procedures
| Inspection |
| 1. |
Switch "OFF" the ignition. |
| 2. |
Disconnect the ATS connector. |
| 3. |
Measure resistance between the ATS terminals 1 and 2. |
| 4. |
Check that the resistance is within the specification.
|
| Removal |
| 1. |
Switch "OFF" the ignition and disconnect the negative (-) battery terminal. |
| 2. |
Remove the front engine room under cover. (Refer to Engjne Mechanical System - "Engine Room Under Cover") |
| 3. |
Disconnect the connector (A) and then remove the ambient temperature sensor (B).
|
| Installation |
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing. |
| 1. |
Install in the reverse order of removal. |
Accelerator Position Sensor (APS)
Specifications
Specification
Accelerator
Position
Output Voltage (V) [Vref = 5V]
APS1
APS2
C.T
0. ...
Injector
Specifications
Specification
Item
Specification
Coil Resistance (Ω)
1.4 - 1.6 [20°C(68°F)]
Description and operati ...
Other information:
Kia Stinger CK 2018-2024 Service Manual: Rear Seat Back Cover
Components and components location Component Location 1. Rear back side seat assembly [LH] 2. Rear seat back assembly [LH] 3. Rear seat back assembly [RH] 4. Rear back side seat assembly [RH] Repair procedures Replacement ...
Kia Stinger CK 2018-2024 Service Manual: Cruise Control Switch
Components and components location Components 1. Left Remote Control Switch (Audio + Bluetooth + Voice) 2. Right Remote Control Switch (Trip Computer + ACC + SCC) Schematic diagrams Circuit Diagram [Audio + Blueto ...
