Kia Stinger: Air Conditioning System / Auto Defogging Sensor (DATC only)

Kia Stinger CK 2018-2024 Service Manual / Heating, Ventilation And Air Conditioning / Air Conditioning System / Auto Defogging Sensor (DATC only)

Description and operation

Description

Installed on the windshield glass, the auto defogging sensor judges and sends signal to blow out wind for defogging if moisture occurs. On receiving the signal from the sensor, the air conditioner control module restrains moisture and eliminates fog by controlling the intake actuator, A/C, auto defogging actuator, blower motor rpm, and mode actuator.

Repair procedures

Inspection

To inspect and diagnose the sensor, refer to Self-Diagnostic procedure and DTC guide.

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Remove the auto defogging sensor cover (A).

3.	Remove the auto defogging sensor (A) after disconnecting the auto defogging sensor connector (B).

4.	Install in the reverse order of removal.

Ambient Temperature Sensor

Description and operation Description Located in front of the condenser, the ambient temperature sensor detects the ambient air temperature. It is a negative type thermistor; resistanc ...

Blower

...

Other information:

Kia Stinger CK 2018-2024 Service Manual: Rear Shock Absorber

Components and components location Components 1. Lock nut 2. Rear insulator 3. Bumper stopper 4. Dust cover 5. Shock absorber Repair procedures Removal 1. Remove wheel nuts, rear wheel and tire (A) from hub. ...

Kia Stinger CK 2018-2024 Service Manual: Crankshaft

Repair procedures Disassembly In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t ...