Kia Stinger: Blower / Blower Motor
Repair procedures
| Inspection |
| 1. |
Connect the battery voltage and check for blower motor operation.
|
| 2. |
If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation. |
| 3. |
Replace the blower motor if it is proved that there is a problem with it. |
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad under cover (A).
|
| 3. |
Disconnect the blower motor connector (A) and then remove the blower motor (B) after loosening the screws.
|
| 4. |
Install in the reverse order of removal. |
Blower Unit
Components and components location
Components Location
1. Blower Unit
Components
1. Inlet seal
2. Inlet duct case [Upper]
...
Field Effect Transistor (DATC)
Repair procedures
Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of the blower
mot ...
Other information:
Kia Stinger CK 2018-2024 Service Manual: Inside Rear View Mirror
Components and components location Component Location 1. Inside rear view mirror Repair procedures Replacement Put on gloves to protect your hands. ...
Kia Stinger CK 2018-2024 Owners Manual: If the engine overheats
If your temperature gauge indicates overheating, you experience a loss of power, or hear loud pinging or knocking, the engine will probably be too hot. If this happens, you should: 1.Pull off the road and stop as soon as it is safe to do so. 2.Place the shift lever in P and set the parking bra ...
Copyright © www.kstinger.com 2015-2024
