Kia Stinger: Crash Pad / Center Fascia Panel

Kia Stinger CK 2018-2024 Service Manual / Body (Interior and Exterior) / Crash Pad / Center Fascia Panel

Components and components location

Component Location

1. Monitor fascia panel

Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the crash pad side cover [RH] (A) by using a remover.

2.	Remove the crash pad garnish [RH] (A) after loosening the mounting screws.

3.	Separate the crash pad passenger side panel (A) after loosening the mounting screws.

4.	Disconnect the start/stop button connector (A) and then remove the crash pad garnish.

5.	Separate the monitor assembly (A) after loosening the mounting screws.

6.	Remove the monitor assembly (A) after disconnect the connectors.

7.	Remove the monitor fascia panel (A) after loosening the mounting screws.

Install in the reverse order of removal.

•	Make sure the connector are connected in properly.

•	Replace any damaged clips.

Cluster Fascia Panel

Components and components location Component Location 1. Cluster fascia panel Repair procedures Replacement ...

Crash Pad Lower Panel

Components and components location Component Location 1. Crash pad lower panel Repair procedures Replacement ...

Other information:

Kia Stinger CK 2018-2024 Service Manual: Rear Upper Arm

Repair procedures Removal [Rear upper arm rear] 1. Remove wheel nuts, wheel and tire (A) from hub. Tightening torque: 107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft) & ...

Kia Stinger CK 2018-2024 Service Manual: Vanity Lamp

Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the vanity lamp (A) using a flat-tip screwdriver. 3. Disconnect the vanity lamp connector (A). Insta ...