Kia Stinger: Crash Pad / Cluster Fascia Panel

Kia Stinger CK 2018-2024 Service Manual / Body (Interior and Exterior) / Crash Pad / Cluster Fascia Panel

Components and components location

Component Location

1. Cluster fascia panel

Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the crash pad side cover [LH] (A) by using a remover.

2.	Separate the crash pad lower panel (A) after loosening the bolts and screws.

3.	Disconnect the crash pad lower switch connector (A).

4.	Remove the crash pad garnish [LH] (A) after loosening the mounting screws.

5.	Remove the crash pad driver side panel (A) after loosening the mounting screws.

6.	Remove the crash pad side cover [RH] (A) by using a remover.

7.	Remove the crash pad garnish [RH] (A) after loosening the mounting screws.

8.	Separate the crash pad passenger side panel (A) after loosening the mounting screws.

9.	Disconnect the start/stop button connector (A) and then remove the crash pad garnish.

10.	Remove the cluster fascia panel (A) by using a remover.

11.

Install in the reverse order of removal.

•	Make sure the connector are connected in properly.

•	Replace any damaged clips.

Crash Pad

Components and components location Components 1. Cowl cross member bar 2. Main wiring 3. Main crash pad 4. Side air vent duct [RH] 5. Crash pad under cover [ ...

Center Fascia Panel

Components and components location Component Location 1. Monitor fascia panel Repair procedures Replacement &n ...

Other information:

Kia Stinger CK 2018-2024 Service Manual: Wide Sunroof

Components and components location Component Location 1. Wide sunroof 2. Wide sunroof switch 3. Roller blind motor & slave controller 4. Glass motor & controller Schematic diagrams Circuit Diagram No. ...

Kia Stinger CK 2018-2024 Service Manual: Rear Assist Arm

Repair procedures Removal 1. Remove wheel nuts, wheel and tire (A) from hub. Tightening torque: 107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft) ...