Kia Stinger: Air Conditioning System / Compressor oil
Repair procedures
| Oil Specification |
| 1. |
The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. |
| 2. |
Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the model of compressor. |
Handling of Oil
| 1. |
The oil should be free from moisture, dust, metal powder, etc. |
| 2. |
Do not mix with other oil. |
| 3. |
The water content in the oil increases when exposed to air. After use, seal oil from air immediately. (Compressor oil HFC-134a absorbs moisture very easily.) |
| 4. |
The compressor oil must be stored in steel containers, not in plastic containers. |
Compressor Oil Check
The oil used to lubricate the compressor circulates with the refrigerant.
Whenever replacing any component of the system or a large amount of gas leakage occurs, add oil to maintain the original amount of oil.
|
Total volume of oil in system FD46XG OIL 100 ± 10g (3.52 ±0.35 oz.) |
Oil Return Operation
There is close affinity between the oil and refrigerant.
During normal operation, part of the oil recirculates with the refrigerant in the system. When checking the amount of oil in the system, or replacing any component of the system, the compressor must run in advance for oil return operation. The procedure is as follows:
| 1. |
Open all the doors and engine hood. |
| 2. |
Start the engine and air conditioning switch to "ON" and set the blower motor control knob at its highest position. |
| 3. |
Run the compressor for more than 20 minutes between 800 and 1,000 rpm in order to operate the system. |
| 4. |
Stop the engine. |
Air Conditioning System
General safety information and caution
When Handling Refrigerant
1.
R-134a liquid refrigerant is highly volatile. A drop on the skin of your
hand could result in local ...
Refrigerant Line
Repair procedures
Replacement
1.
Discharge refrigerant from the refrigeration system.
2.
Replace faulty tube or hose.
...
Other information:
Kia Stinger CK 2018-2024 Service Manual: Low Pressure Fuel Pump
Repair procedures Inspection [Fuel sender] 1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal. 2. Remove the fuel pump assembly. 3. Using an ohmmeter, measure the resistance between term ...
Kia Stinger CK 2018-2024 Service Manual: Rear Spoiler
Repair procedures Replacement Put on gloves to protect your hands. • Use a plastic panel removal tool to remove ...
