Kia Stinger: Heater / Console ON/OFF Actuator

Kia Stinger CK 2018-2024 Service Manual / Heating, Ventilation And Air Conditioning / Heater / Console ON/OFF Actuator

Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the mode control actuator connector.

Verify that the mode control actuator operates to the defrost mode when 12V is connected to terminal 3 and ground to terminal 7.

Verify that the mode control actuator operates to the vent mode when connected in reverse.

1. -
2. -
3. Cool mode
4. Sensor(+5V)

5. Feedback signal
6. Sensor ground
7. Warm mode

4.	Connect the mode control actuator connector.

5.	Turn the ignition switch ON.

Check the voltage between terminals 5 and 6.

Specification

Door position	Voltage (V)	Error detecting
Cool	1.50 ± 0.15	Low voltage : 1.7V or less High voltage : 4.9V or more
Warm	4.70 ± 0.15	Low voltage : 1.7V or less High voltage : 4.9V or more

The current position of the actuator will be sent to the control unit.

7.	If the measured voltage is not within the specification, substitute with a verified temperature control actuator and check for proper operation.

8.	Replace the mode control actuator if it is proved that there is a problem with it.

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Remove the knee airbag. (Refer to Restraint - "Knee Airbag (KAB) Module")

3.	Disconnect the connector (A) and then remove the temperature control actuator (B) after loosening the mounting screws.

4.	Install in the reverse order of removal.

Console Temperature Control Actuator

Repair procedures Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify t ...

Other information:

Kia Stinger CK 2018-2024 Service Manual: Smart Cruise Control (Stop & Go) (SCC) ECU

Description and operation Description The smart cruise control unit is installed on the front right-hand side of the chassis. A radar sensor is embedded in the front section of the unit. This sensor detects vehicles and objects in front of the vehicle. The radar sensor can detect ...

Kia Stinger CK 2018-2024 Service Manual: Variable Charge Motion Actuator (VCMA)

Components and components location Components ECM directly controls the actuator and the rotation of motor operates the VCM flap of intake manifold in link structure to create tumble in air. Mounted inside the actuator, the motor and position sensor sense the position of flap and s ...