Kia Stinger: Drive Belt System / Drive Belt

Kia Stinger CK 2018-2024 Service Manual / Engine Mechanical System / Drive Belt System / Drive Belt

Repair procedures

Removal

1.	Remove the engine room front under cover. (Refer to Engine and Transmission Assembly - "Engine Room Under Cover")

2.	For release the tension, turn the drive belt tensioner (A) counterclockwise then remove the drive belt (B).

Remove the water pump belt.

(1)	Insert the SST (09252-C1000) between the water pump pulley and the water pump belt.

(2)	Remove the water pump belt (A) by turning the damper pulley clockwise.

Inspection

Visually check the belt for excessive wear, frayed cords etc.

If any defect has been found, replace the drive belt.

Cracks on the rib side of a belt are considered acceptable. If the belt has chunks missing from the ribs, it should be replaced.

Installation

Install the water pump belt.

(1)	Insert the SST (09252-C1000) between the water pump pulley and the water pump belt

(2)

Install the water pump belt (A) by turning the damper pulley clockwise.

Install the water pump belt while being careful not to damage the water pump belt caused by water pump pulley mounting bolt (B).

2.	For release the tension, turn the drive belt tensioner (A) counterclockwise then install the drive belt (B).

3.	Install the other parts in the reverse order of removal.

Drive Belt Tensioner

Repair procedures Removal and Installation 1. Remove the drive belt. (Refer to Drive Belt System - "Drive Belt") 2. Remove the dri ...

Other information:

Kia Stinger CK 2018-2024 Service Manual: E-CVVT motor

Components and components location Components Appearance of E-CVVT is similar to that of hydraulic CVVT. Connector that drives DC motor and protection cover that protects the motor are mounted on the upper part. DC motor that drives the CVVT is mounted inside and covering part is s ...

Kia Stinger CK 2018-2024 Owners Manual: Turn signals and lane change signals

The ignition switch must be on for the turn signals to function. To turn on the turn signals, move the lever up or down (A). The green arrow indicators on the instrument panel indicate which turn signal is operating. They will self-cancel after a turn is completed. If the indicator continues ...