Kia Stinger: ECS(Electronic Control Suspension) System / ECS-G Sensor
Repair procedures
| Removal |
[Body G Sensor]
| Front |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Remove wheel nuts, wheel and tire (A) from hub.
|
| 3. |
Remove the front wheel guard. (Refer to Body - "Front wheel guard") |
| 4. |
Disconnect the ECS-G sensor connector (A). |
| 5. |
Loosen the nut and then ECS-G sensor (B). [RH,LH]
|
| 6. |
Install in the reverse order of removal. |
| Rear |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Remove wheel nuts, wheel and tire (A) from hub.
|
| 3. |
Remove the rear wheel guard. (Refer to Body - "Rear wheel guard") |
| 4. |
Disconnect the ECS-G sensor connector (A). |
| 5. |
Loosen the nut and then ECS-G sensor (B). [RH]
|
| 6. |
Install in the reverse order of removal. |
| [Wheel-G Sensor] |
| [Front] |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Remove wheel nuts, wheel and tire (A) from hub.
|
| 3. |
Remove the front wheel guard.
|
| 4. |
Loosen the wheel speed sensor bolt (A) and then disconnect the wheel speed sensor.
|
| 5. |
Remove the wheel speed sensor bracket (A).
|
| 6. |
Disconnect the ECS connector (A) and then remove the wheel speed sensor bracket.
|
| 7. |
Remove the bracket (A) and then disconnect the connector (B).
|
| 8. |
Install in the reverse order of removal. |
[Rear]
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Remove wheel nuts, wheel and tire (A) from hub.
|
| 3. |
Remove the rear wheel guard. (Refer to Body - "Rear wheel guard") |
| 4. |
Loosen the wheel speed sensor bolt and then remove the wheel speed sensor.
|
| 5. |
Disconnect the ECS sensor connector (A) and then remove the bracket (B).
|
| 6. |
Install in the reverse order of removal. |
ECS Control Unit
Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the luggage side trim.
(Refer to B ...
Tires/Wheels
...
Other information:
Kia Stinger CK 2018-2024 Service Manual: Rear Stabilizer Bar
Repair procedures Removal 1. Remove wheel nuts, wheel and tire (A) from hub. Tightening torque: 107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft) ...
Kia Stinger CK 2018-2024 Service Manual: Rear Door
Components and components location Components 1. Rear door trim panel 2. Rear door module 3. Rear door panel 4. Rear door fixed glass & weatherstrip 5. Rear door drive channel 6. Rear door side weatherstrip 7. Rear door body side weatherstrip ...
