Kia Stinger CK: Front Driveshaft Assembly / BJ Boot

Repair procedures
Replacement
1.

Remove the front driveshaft.

(Refer to Driveshaft Assembly - “Front Driveshaft”)

2.

Remove the TJ joint assembly.

(Refer to Driveshaft Assembly - “TJ Joint”)

3.

Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).

4.

Remove the BJ boot.

5.

Install in the reverse order of removal.

  
•

Do not disassemble the BJ assembly.

•

Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.

•

The boot band should be replaced with a new one.

6.

Check the front alignment.

(Refer to Suspension System - "Alignment")

Other information:

Kia Stinger (CK) 2018-2023 Service Manual: Delivery Pipe

Repair procedures Removal 1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2. Switch "OFF" the ignition and disconnect the negative (-) battery terminal. 3. Remove the intake manifold.

Kia Stinger (CK) 2018-2023 Service Manual: Height Sensor

Components and components location Components Description and operation Description Height sensor sense a change of vehicle height and send this signal to AFS ECU. Height sensor is comprised of rotor/stator, PCB coil and sensor lever. Sensor check the lever angle value which is calculated by the magnetic field of stator.

Categories

 
Copyright © 2026 www.kstinger.com 0.0177