Kia Stinger CK: Driving your vehicle / ISG (Idle Stop and Go) system
Contents:
Your vehicle may be equipped with the ISG system, which reduces fuel consumption
by automatically shutting down the engine, when the vehicle is at a standstill.
(For example : red light, stop sign and traffic jam)
The engine starts automatically as soon as the starting conditions are met.
The ISG system is ON whenever the engine is running.
✽ NOTICE
When the engine automatically starts by the ISG system, some warning lights
(ABS, ESC, ESC OFF, EPS or Parking brake warning light) may turn on for a few seconds.
This happens because of low battery voltage. It does not mean the system has malfunctioned.
Condition of ISG system operation
The ISG system will operate under the following condition:
- The driver’s seat belt is fastened.
- The driver’s door and engine hood are closed.
- The brake vacuum pressure is adequate.
- The battery is sufficiently charged.
- The outside temperature is between 14°F to 95°F (-10°C to 35°C).
- The engine coolant temperature is not too low.
✽ NOTICE
- If the ISG system does not meet the operation condition, the ISG system
is deactivated. The light on the ISG OFF button will illuminate and a message
“Auto Stop conditions not met” will appear on the LCD display.
- If the light or notice comes on continuously, please check the operation
condition.
ISG system deactivation

- If you wish to deactivate the ISG system, press the ISG OFF button (1).
The light on the ISG OFF button will illuminate.
- If you press the ISG OFF button again, the system will be activated and
the light on the ISG OFF button will turn off.
Other information:
Kia Stinger (CK) 2018-2023 Owner's Manual: Vacuum Pump
Components and components location
Components
3.3 T-GDI LAMBDA II
1. Vacuum pump
2. Vacuum pump bracket
2.0 T-GDI THETA II
1. Vacuum pump
2. Vacuum pump bracket
Repair procedures
Removal
[3.3 T-GDI LAMBDA II]
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Kia Stinger (CK) 2018-2023 Owner's Manual: Cooling Fan
Components and components location
Components
[BLDC (Brushless DC)
motor type]
1. Radiator
2. Cooling fan assembly
3. Reservoir tank
[DC motor type]
1. Cooling fan
2. Cooling fan motor
3. Cooling fan shroud
4. Cooling fan controller
5. Reservoir tank
Description and operation
Description
The cooling fan operates in 2 stages (HIGH/LOW).