Kia Stinger: Evaporative Emission Control System / Fuel Filler Cap
Description and operation
| Description |
A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gaskets on the fuel filler cap and the filler neck flange contact each other, the ratchet produces a loud clicking noise indicating that the seal has been set.
Purge Control Solenoid Valve (PCSV)
Specifications
Specification
Item
Specification
Coil Resistance (Ω)
18.5 - 22.5 [20°C(68°F)]
Description and opera ...
Fuel Tank Air Filter
Repair procedures
Removal
1.
Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
2.
Remove the rear-left whe ...
Other information:
Kia Stinger CK 2018-2024 Service Manual: Rear Door Inside Handle
Repair procedures Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Rremove the rear door inside handle (A) after loosening mounting screws. 3. Install in the reverse ...
Kia Stinger CK 2018-2024 Service Manual: Propeller Shaft
Repair procedures Inspection CV Joint and boots 1. Shift the transmission lever to Neutral. 2. Raise the vehicle off the ground, and support it with safety stands in the proper locations. 3. Check the center bearing (A) ...
Copyright © www.kstinger.com 2015-2024
