Contents:
WARNING - Windshield heating
Do not use the
or
position during cooling operation
in extremely humid weather. The difference between the temperature of the outside
air and the windshield could cause the outer surface of the windshield to fog up,
causing loss of visibility. In this case, set the mode selection to the
position and fan speed control to
the lower speed.
The system automatically selects the outside (fresh) air position when the climate control system operates over a certain period of time (approximately 30 minutes) in low temperature with the recirculated air position selected.
To cancel or reset the Automatic Ventilation
When the air conditioning system is on, select Face Level
mode and while pressing the A/C button,
press the recirculated air position button five times within three seconds.
When the automatic ventilation is canceled, the indicator blinks 3 times. When the automatic ventilation is activated, the indicator blinks 6 times.
If the battery is discharged or detached, the automatic ventilation will be reset. Adjust the feature accordingly.
The smart ventilation system maintains pleasant/fresh air condition inside the passenger compartment by automatically detecting/controlling the temperature and humidity when you drive the vehicle with the climate control system in the OFF position. When the smart ventilation system starts to operate, the message, “SMART VENTILATION ON” appears for 5 seconds.
Kia Stinger (CK) 2018-2023 Owner's Manual: Sub Fuel Sender
Repair procedures Removal 1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2. Switch "OFF" the ignition and disconnect the negative (-) battery terminal. 3. Remove the rear seat cushion.Kia Stinger (CK) 2018-2023 Owner's Manual: Seat Ventilation Unit
Components and components location Component Location 1. Seat ventilation blower 2. Seat ventilation unit (Assist seat only) Schematic diagrams Circuit Diagram Repair procedures Removal Seat Ventilation Unit 1. Disconnect the negative (-) battery terminal.