Kia Stinger CK: Fuel Delivery System / Fuel Tank
Repair procedures
| Removal |
| 1. |
Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - "Release Residual Pressure in Fuel Line") |
| 2. |
Switch "OFF" the ignition and disconnect the negative (-) battery terminal. |
| 3. |
Remove the rear seat cushion. (Refer to Body - "Rear Seat Assembly") |
| 4. |
Remove the fuel pump service cover (A) after loosening the mounting screws.
|
| 5. |
Disconnect the fuel feed quick-connector (A). |
| 6. |
Disconnect the fuel pressure sensor connector (B). |
| 7. |
Disconnect the fuel pump connector (C).
|
| 8. |
Remove the sub fuel sender service cover (A) after loosening the mounting screws.
|
| 9. |
Disconnect the sub fuel sender connector (A).
|
| 10. |
Lift the vehicle. |
| 11. |
Remove the center muffler assembly. (Refer to Engine Mechanical System - "Muffler") |
| 12. |
Remove the propeller shaft assembly. (Refer to Driveshaft and Axle - "Propeller Shaft") |
| 13. |
Disconnect the fuel filler hose (A) and leveling hose (B).
|
| 14. |
Disconnect the ventilation (A).
|
| 15. |
Support the fuel tank with jack (A). |
| 16. |
Remove the fuel tank installation nut (B) and then loosen the fuel tank.
|
| 17. |
Remove the fuel tank (A).
|
| Installation |
| 1. |
Install in the reverse order of removal. |
Other information:
Kia Stinger (CK) 2018-2023 Service Manual: Starting System
Description and operation Description The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable. When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil.Kia Stinger (CK) 2018-2023 Service Manual: Steering Angle Sensor
Description and operation Description Steering Wheel Angle Sensor detects rotating direction of the vehicle.The rotating direction detected by the sensor is sent to the HECU as CAN signal via CAN communication. HECU detects speed of the steering wheel handling and the angle with this CAN signal. HECU also uses this signal as the input signal to control anti-roll.Categories
- Manuals Home
- Kia Stinger Owners Manual
- Kia Stinger Service Manual
- New on site
- Most important about car
