Kia Stinger: Crash Pad / Glove Box Housing

Kia Stinger CK 2018-2024 Service Manual / Body (Interior and Exterior) / Crash Pad / Glove Box Housing

Components and components location

Component Location

1. Glove box housing

Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the crash pad side cover [RH] (A) by using a remover.

2.	Remove the crash pad garnish [RH] (A) after loosening the mounting screws.

3.	Pull out the both sides stopper (B) from the glove box (A).

4.	Remove the air damper (A) from the glove box (B).

5.	Remove the lock pins (A) and then remove the glove box (B).

6.	Separate the crash pad under cover [RH] (A).

7.	Disconnect the lamp connector (A) and remove crash pad under cover.

8.	Separate the glove box housing (A) after loosening the mounting screws, bolts, and nuts.

9.	Remove the glove box housing after disconnecting the connector (A), (B).

10.

Install in the reverse order of removal.

•	Make sure the connector are connected in properly.

•	Replace any damaged clips.

Steering Column Shroud Panel

Components and components location Component Location 1. Steering column shroud upper panel 2.Steering column shroud lower panel Repair procedu ...

Crash Pad Center Panel

Components and components location Component Location 1. Crash pad passenger side panel Repair procedures Replacement ...

Other information:

Kia Stinger CK 2018-2024 Service Manual: Vacuum Pump

Components and components location Components 3.3 T-GDI LAMBDA II 1. Vacuum pump 2. Vacuum pump bracket 2.0 T-GDI THETA II 1. Vacuum pump 2. Vacuum pump bracket Repair procedures Remov ...

Kia Stinger CK 2018-2024 Service Manual: Shift Cable

Components and components location Components 1. Manual control lever 2. Shift cable 3. Shift lever assembly 4. Knob Repair procedures Removal 1. Shift the gear to "N". 2. Loosen the ...