Kia Stinger: Heater / Heater Core
Repair procedures
1. |
Disconnect the negative (-) battery terminal.
|
2. |
After loosening the nuts and bolts, remove the main crash pad and cowl
cross bar assembly altogether.
(Refer to Heater - "Heater Unit")
|
3. |
Remove the heater core (A).
|
4. |
Install in the reverse order of removal.
• |
Replace the O-rings with new ones at each fitting, and apply
a thin coat of refrigerant oil before installing them. Be sure to
use the right O-rings for R-134a, R-1234yf to avoid leakage.
|
• |
Immediately after using the oil, replace the cap on the container,
and seal it to avoid moisture absorption.
|
• |
Do not spill refrigerant oil on the vehicle as it may damage
the paint. If refrigerant oil comes in contact with the paint, wash
it off immediately.
|
• |
Apply sealant to the grommets.
|
• |
Make sure that there is no air leakage.
|
• |
Charge the system and test its performance.
|
• |
Do not interchange the inlet and outlet heater hoses and install
the hose clamps securely.
|
• |
Refill the cooling system with engine coolant.
|
|
Components and components location
Component Location
1. Heater Unit
Components
[LH]
1. Air guard
2. Anti noise p ...
Description and operation
Description
The heater unit consists of mode control actuator and temperature control actuator.
Located in the heater unit, the temperature control actuator ...
Other information:
Components and components location
Components
1. Master cylinder
2. Brake booster
3. Brake reservoir
Repair procedures
Removal
[LHD]
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
...
Components and components location
Components
Repair procedures
Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the overhead console lamp (A) after loosening the mounting screws.
...