Kia Stinger: Blower / Intake Actuator
Description and operation
| Description |
Located in the blower unit, the intake actuator regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes.
Repair procedures
| Inspection |
| 1. |
Turn the ignition switch OFF. |
| 2. |
Disconnect the intake actuator connector. |
| 3. |
Verify that the actuator operates to the recirculation position when 12V is connected to terminal 3 and ground to terminal 7. Verify that the intake actuator operates to the recirculated air position when connected in reverse.
|
| 4. |
Connect the intake actuator connector. |
| 5. |
Turn the ignition switch ON. |
| 6. |
Check the voltage between terminals 5 and 6. Specification
The current position of the actuator will be sent to the control unit. |
| 7. |
If the intake actuator does not operate well, substitute with a known-good intake actuator and check for proper operation. |
| 8. |
Replace the intake actuator if it is proved that there is a problem with it. |
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the glove box housing. (Refer to Body - "Glove Box Housing") |
| 3. |
Remove the passenger side shower duct (A) after loosening the screw.
|
| 4. |
Disconnect the connector (A) and then remove the intake actuator (B) after loosening the mounting screw.
|
| 5. |
Install in the reverse order of removal. |
Climate Control Air Filter
Description and operation
Description
Located in the blower unit, the climate control air filter eliminates foreign
materials and odor. The particle filter performs the roles of an od ...
Controller
...
Other information:
Kia Stinger CK 2018-2024 Service Manual: Power Door Lock Switch
Repair procedures Inspection Diagnosis With KDS 1. The body electrical system can be quickly diagnosed for failed parts by using vehicle diagnostic system (KDS). The diagnostic system (KDS) provides the following information. (1) Self diag ...
Kia Stinger CK 2018-2024 Service Manual: Rear Door Inside Handle
Repair procedures Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Rremove the rear door inside handle (A) after loosening mounting screws. 3. Install in the reverse ...
