Kia Stinger: Integrated Memory Seat (IMS) System / Integrated Memory Seat (IMS) Unit

Kia Stinger CK 2018-2024 Service Manual / Body Electrical System / Integrated Memory Seat (IMS) System / Integrated Memory Seat (IMS) Unit

Components and components location
Components

Connector Pin Information

No
Connector A
Connector B
Connector C
1
Cushion extension motor (Front)
Battery (+)
Slide switch (Front)
2
Recline motor (Front)
Ground
Recline switch (Front)
3
Rear height motor (Up)
Battery (+)
Frout tilt switch (Up)
4
Slide motor (Front)
-
Rear height switch (Up)
5
Cushion extension motor (Rear)
Ground
Cushion extension switch (Front)
6
Recline motor (Rear)

B-CAN (High)
7
Front tilt motor (Up)
B-CAN (Low)
8
Front tilt motor (Down)
-
9
Rear height motor (Down)
-
10
Slide motor (Rear)
Slide hall sensor
11

Front tilt hall sensor
12
-
13
Seat position sensor power
14
IGN1
15
Slide switch (Rear)
16
Recline switch (Rear)
17
Front tilt switch (Down)
18
Rear height switch (Down)
19
Cushion extension switch (Rear)
20
Ground
21
-
22
-
23
-
24
Recline hall sensor
25
Rear height hall sensor
26
Cushion extension hall sensor
27
-
28
Battery (+)

Schematic diagrams
Circuit Diagram

Repair procedures
Removal
1.

Before removing the driver side seat assembly, pull it upward to the maximum by pushing the front seat height adjusting switch (A).

2.

Disconnect the negative (-) battery terminal

3.

Remove the driver front seat assembly.

(Refer to Body - "Front Seat Assembly")

4.

Disconnect the integrated memory seat unit connectors (A).

5.

Remove the integrated memory seat unit (A) after loosening the mounting screws.

Installation
1.

Install the integrated memory seat unit.

2.

Connect the integrated memory seat unit connectors.

3.

Install the driver front seat assembly.

4.

Connect the negative (-) battery terminal.

5.

Perform the seat limit position setting using the KDS.

Integrated Memory Seat (IMS) System
Specifications Specifications Memory Power Seat Unit Item Specifications Rated voltage DC 12 V Operating volta ...

Integrated Memory Seat (IMS) Switch
Components and components location Components Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove ...

Other information:

Kia Stinger CK 2018-2024 Service Manual: Adaptive Front-Lighting System (AFS) Unit


Components and components location Components Schematic diagrams Schematic Diagrams Description and operation Description AFS Unit (ECU) AFS located in Cockpit Module is provided information of vehicle (steering wheel signal, vehicle speed, inclin ...

Kia Stinger CK 2018-2024 Owners Manual: Certification label


The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross Vehicle Weight Rating). The GVWR includes the weight of the vehicle, all occupants, fuel and cargo. This ...

Copyright © www.kstinger.com 2015-2024