Kia Stinger: Engine Control System / Knock Sensor (KS)
Specifications
Item
|
Specification
|
Capacitance (pF)
|
850 - 1,150
|
Resistance (MΩ)
|
Approx. 1
|
Description and operation
Knocking is a phenomenon characterized by undesirable vibration and noise that
can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and
senses engine knocking.
When knocking occurs, the vibration from the cylinder block is applied as pressure
to the piezoelectric element, and the sensor produces voltage signal to ECM. On
receipt of this signal, ECM will control the ignition timing by retarding the ignition
timing and then advancing the ignition timing when the knocking disappears. This
sequential control can improve engine power, torque and fuel economy.
Schematic diagrams
Harness Connector
Repair procedures
| 1. |
Switch "OFF" the ignition.
|
| 2. |
Disconnect the knock sensor connector.
|
| 3. |
Measure resistance between the injector terminals 1 and 2.
|
| 4. |
Check that the resistance is within the specification.
|
Specification: About 4.87 MΩ [20°C(68°F)]
|
|
| 1. |
Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
|
| 2. |
Remove the intake manifold.
(Refer to Engine Mechanical System - “Intake Manifold”)
|
| 3. |
Remove the delivery pipe & injector assembly.
(Refer to Fuel Delivery System - "Delivery Pipe")
|
| 4. |
Remove the knock sensor (A) after loosening the mounting bolt from the
cylinder block.
|
Knock sensor installation bolt :
18.6 - 23.5 N·m (1.9 - 2.4 kgf·m, 13.7 - 17.4 lb·ft)
|
|
| • |
Install the component to the specified torques.
|
| • |
Note that internal damage may occur when the component is dropped.
If the component has been dropped, inspect before installing.
|
|
| 1. |
Install in the reverse order of removal.
|
Specifications
Specifications
Item
Specification
Air Cap (mm)
0.2 - 2.0
Description and operation
Description
...
Specifications
Specification
HO2S [Bank 1/Sensor
1]
Item
Specification
Heater Resistance (Ω)
2.5 - 4.0 [20°C(68°F)]
...
Other information:
■ Type A
■ Type B
• Press the lens (1) to turn ON the map lamp.
To turn the map lamp OFF press the lens (1) again.
• (2) : DOOR mode
- The map lamp and room lamp come on when a door is opened. The lamps go out
after approximately 30 seconds.
- The map lamp and room lamp come on f ...
Special service tools
Special Service Tools
Tool Name / Number
Illustration
Description
Oil seal installer (Main Shaft)
0K473-J5100
Installation of transfer case oil seal (Main Shaft).
Used with ...
Camshaft Position Sensor (CMPS)
Heated Oxygen Sensor (HO2S)