Kia Stinger: Lubrication System / Oil Level Gauge & Pipe
Repair procedures
1. |
Remove the oil level gauge (A).
|
2. |
Remove the engine room front under cover and LH side cover.
(Refer to Engine and Transmission Assembly - "Engine Room Under Cover")
|
3. |
Remove the LH engine mounting support bracket nut (A).
Tightening torque :
63.7 - 83.4 N·m (6.5 - 8.5 kgf·m, 47.0 - 61.5 Ib·ft)
|
|
4. |
Remove the alternator.
(Refer to Engine Electrical System - "Alternator")
|
5. |
Install the jack to the edge of upper oil pan to support the engine.
Insert the rubber block between jack and oil pan.
|
|
6. |
Remove the LH engine support bracket (A).
Tightening torque :
49.0 - 63.7 N·m (5.0 - 6.5 kgf·m, 36.2 - 47.0 lb·ft)
|
|
7. |
Remove the oil level pipe (A).
Tightening torque :
9.8 - 11.8 N·m (1.0 - 1.2 kgf·m, 7.2 - 8.7 lb·ft)
|
|
8. |
Install in the reverse order of removal.
|
Repair procedures
Removal
1.
Disconnect the battery negative terminal.
2.
Remove the alternator.
(Refer to Engine Electrical System - "Alter ...
Components and components location
Components
1. Front oil seal
2. E-CVVT cover plug
3. E-CVVT assembly cover
4. Timing chain cover
5. Timing chain tensi ...
Other information:
Components and components location
Components
1. Brake lamp switch
2. Brake pedal
Description and operation
Operation
Operation principle
of inductive non-contact switch
1.
Use the high frequency magnetic field and t ...
Components and components location
Components
[Standard]
1. Caliper housing
2. Brake member
3. Brake pad assembly [IN]
4. Retainer
5. Brake pad assembly [OUT]
6. Brake pad return spring
[Brembo]
1. ...