Kia Stinger: Lubrication System / Oil Pressure Switch
Repair procedures
| Removal |
| 1. |
Disconnect the battery negative terminal. |
| 2. |
Remove the alternator. (Refer to Engine Electrical System - "Alternator") |
| 3. |
Disconnect the oil pressure switch connector (A) and then remove the oil pressure switch (B).
|
| 4. |
Install in the reverse order of removal.
|
| Inspection |
| 1. |
Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch.
|
| 2. |
Check the continuity between the terminal and the body when the fine wire is pushed. If there is continuity even when the fine wire is pushed, replace the switch. |
| 3. |
If there is no continuity when a 50kPa (0.50kgf/cm², 7.25psi) is applied through the oil hole, the switch is operating properly. Check for air leakage. If air leaks, the diaphragm is broken. Replace it.
|
Balance Shaft & Oil Pump
Repair procedures
Removal
BSM (Balance Shaft
Module) Chain System
1.
Remove the timing chain.
(Refer to Timing System - "Timing Chain")
2. ...
Oil Level Gauge & Pipe
Repair procedures
Removal and Installation
1.
Remove the oil level gauge (A).
2.
Remove the engine room front under cover and LH side cover. ...
Other information:
Kia Stinger CK 2018-2024 Service Manual: Air Conditioner Refrigerant/Compressor
Repair procedures Refrigerant Recovery When removing HFC-134a (R-134a) from the air conditioning system, use only U.L.-listed service equipment certified to meet the requirements of SAE J2210. • ...
Kia Stinger CK 2018-2024 Service Manual: Pantoscopic Camera
Components and components location Components Front View Camera Side View Camera Rear View Camera Repair procedures Removal In case of bad quality or p ...
