Kia Stinger: Parking Distance Warning (PDW) / Parking Distance Warning (PDW) Switch

Kia Stinger CK 2018-2024 Service Manual / Body Electrical System / Parking Distance Warning (PDW) / Parking Distance Warning (PDW) Switch

Components and components location
Components

Schematic diagrams
Circuit Diagram

Repair procedures
Removal
  

Put on gloves to protect your hands.

  

When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

Take care not to bend or scratch the trim and panels.

1.

Disconnect the negative (-) battery terminal.

2.

Remvoe the console upper complete (A) by using a remover.

3.

Disconnect the connectors (A) from the console upper complete.

4.

Remove the connector (A) from the console floor switch complete.

5.

Remove the console floor switch complete (A) after loosening the mounting screws.

Installation
1.

Install the console floor switch complete.

2.

Install the connector from the console floor switch complete.

3.

Connect the connectors from the console upper complete.

4.

Install the console upper complete.

5.

Connect the negative (-) battery terminal.

  

Make sure that the connectors are plugged in properly.

Check the PDW system for normal operation.

Parking Distance Warning (PDW) Sensor
Components and components location Components Repair procedures Removal Parking Distance Warning-Forward (PDW-F) Sensor 1. Disconnect the negative (-) ...

Fuel Filler Door
Components and components location Component Location 1. Fuel filler door open switch 2. Fuel filler door release actuator ...

Other information:

Kia Stinger CK 2018-2024 Service Manual: Active hood sensor & unit assembly


Repair procedures Replacement 1. Disconnect the negative battery terminal.    After disconnecting the cables, wait at least 30 seconds. 2. ...

Kia Stinger CK 2018-2024 Service Manual: Driver Airbag (DAB) Module and Clock Spring


Description and operation Description Driver Airbag (DAB) is installed in the steering wheel and electrically connected to SRSCM via the clock spring. It protects the driver by deploying the airbag when frontal crash occurs. The SRSCM determines deployment of the Driver Airbag (D ...

Copyright © www.kstinger.com 2015-2024