Kia Stinger: Airbag Module / Passenger Airbag (PAB) Module
Description and operation
Installed inside the crash pad, the passenger airbag (PAB) protects the front
passenger in the event of a frontal crash. The SRSCM determines if and when to deploy
the PAB.
Never attempt to measure the circuit resistance of the airbag module
(squib) even if you are using the specified tester. If the circuit resistance
is measured with a tester, accidental airbag deployment will result in serious
personal injury.
|
Components and components location
1. Passenger Airbag (PAB)
|
|
Repair procedures
1. |
Disconnect the negative battery terminal, and wait for at least three
minutes before beginning to work.
|
2. |
Remove the main crash pad.
(Refer to Body (Interior and Exterior) - "Main Crash Pad Assembly")
If the PAB has been deployed, replace the damaged crash pad.
|
|
3. |
Remove the PAB mounting bolts.
Tightening torque :
3.8 - 5.8 N·m (0.39 - 0.6 kgf·m, 2.8 - 4.3 lb·ft)
|
|
1. |
Disconnect the battery negative terminal, and wait for at least three
minutes before beginning to work.
|
2. |
Install in the reverse order of removal.
|
3. |
Reconnect the negative battery terminal.
|
4. |
After installing the passenger airbag (PAB), confirm proper system operation:
Switch "ON" the ignition. The SRS indicator light should turn on for
about six seconds and then off.
|
Description and operation
Description
Driver Airbag (DAB) is installed in the steering wheel and electrically connected
to SRSCM via the clock spring.
It protects the driver by deplo ...
Description and operation
Description
Installed inside the front seat, the side airbags (SAB) protect the driver and
front passenger from danger in the event of a side crash. The SRSCM ...
Other information:
Special service tools
Special Service Tools
Tool Name / Number
Illustration
Description
09495-3K000
Band installer
Installation of ear type boot band
09495-39100
Band instal ...
Description and operation
Description
The evaporator temperature sensor detects the evaporator core temperature and
interrupts compressor relay power in order to prevent evaporator from freezing by
excessive cooling.
Repair procedures
Inspection
1.
...