Kia Stinger: Power Door Mirrors / Power Door Mirror Switch

Kia Stinger CK 2018-2024 Service Manual / Body Electrical System / Power Door Mirrors / Power Door Mirror Switch

Components and components location

Components

Schematic diagrams

Circuit Diagram

Front Safety + IMS Type

Front Safety + Non-IMS Type

Repair procedures

Inspection

Diagnosis With KDS

The body electrical system can be quickly diagnosed for failed parts by using vehicle diagnostic system (KDS).

The diagnostic system (KDS) provides the following information.

(1)	Self diagnosis : Checks and displays the failure code (DTC)

(2)	Current data : Checks the system input/output data state

(3)	Actuation test : Checks the system operating condition

(4)	Additional function : Other controls such as the system option and zero point

2.	Select the 'Car model' and the system to be checked in order to check the vehicle with the tester.

3.	Select the 'Driver seat or Assistant seat door module (DDM/ADM)' to check the driver seat or assistant door module (DDM/ADM).

4.	Select the "Current Data" menu to check the current state of the input/output data. The input/output data for the sensors corresponding to the driver seat or assist door module (DDM/ADM) can be checked.

5.	If you will check the power door mirror operation forcefully, select "Actuation test".

Removal

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.

•	Be careful to store and handle the trim when removing/installing because lubricant and oil can leave a stain on the trim.

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front door trim. (Refer to Body - "Front Door Trim")

3.	Disconnect the power window switch connector (A).

4.	Remove the power window switch (A) after loosening the mounting screws.

Installation

1.	Install the power window switch.

2.	Connect the power window switch connector.

3.	Install the front door trim.

4.	Connect the negative (-) battery terminal.

Power Door Mirrors

Components and components location Component Location 1. Power door mirror 2. Power door mirror switch 3. Power folding mirror switch ...

Power Door Mirror Actuator

Components and components location Components 1. Side repeater lamp 2. BCW Indicator 3. AVM Camera 4. Puddle lamp Repair procedures Insp ...

Other information:

Kia Stinger CK 2018-2024 Service Manual: Water Jacket Separator

Repair procedures Removal and Installation 1. Remove the cylinder head. (Refer to Cylinder Head Assembly - "Cylinder Head") 2. Remove the water jacket separator (A). 3. Install the other parts in the re ...

Kia Stinger CK 2018-2024 Owners Manual: USB charger

The USB charger is designed to recharge devices using a USB cable. The electrical devices can be recharged when the Engine Start/Stop button is in ACC/ON/START position. The battery charging state may be monitored on the electrical device. Disconnect the USB cable from the USB port after use. ...