Kia Stinger: Seat Electrical / Power Seat Control Switch

Kia Stinger CK 2018-2024 Service Manual / Body Electrical System / Seat Electrical / Power Seat Control Switch

Repair procedures

Inspection

Diagnosis With KDS

The body electrical system can be quickly diagnosed for failed parts by using the vehicle diagnostic system (KDS).

The diagnostic system (KDS) provides the following information.

(1)	Self diagnosis : Checks and displays the failure code (DTC).

(2)	Current data : Checks the system input/output data state.

(3)	Actuator test : Checks the system operating condition.

(4)	Additional function : Other controls such as the system option and zero point adjustment.

2.	Select the 'Car model' and the system to be checked in order to check the vehicle with the tester.

3.	Select the 'Power seat module (PSM)' to check the power seat module (PSM).

4.	Select the 'Current data' menu to check the current state of the input/output data. The input/output data for the sensors corresponding to the power seat module (PSM) can be checked.

Seat Control Switch

1.	With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch.

Driver's Seat / IMS Type

[16Way (EXT + Bolster) Type]

[14Way (EXT) Type]

[14Way (SLB) Type]

[12Way Type]

[8Way Type]

Driver's Seat / Non-IMS Type

[14Way (EXT) Type]

[12Way Type]

[8Way Type]

Assist's Seat / Non-IMS Type

[12Way (Walk-In) Type]

[12Way Type]

[8Way Type]

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front seat outer shield cover. (Refer to Body - "Front Seat Outer Shield Cover")

3.	Remove the slide knob (A) and reclining knob (B).

4.	Remove the power seat control switch (A) after loosening the mounting screws.

Installation

1.	Install the power seat control switch.

2.	Install the slide knob and reclining knob.

3.	Install the front seat outer shield cover.

4.	Connect the negative (-) battery terminal.

Power Seat Motor

Components and components location Component Location 1. Slide motor 2. Reclining motor 3. Lumber support motor 4. Front height motor 5. Cushion extensio ...

Seat Heater Unit

Components and components location Component Location Front Seat Heater 1. Front seat heater unit (Assist seat only) 2. Front seat heater (Back) ...

Other information:

Kia Stinger CK 2018-2024 Service Manual: Fuel Filler Door Open Switch

Components and components location Components Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") ...

Kia Stinger CK 2018-2024 Owners Manual: Blind-spot Collision Warning (BCW)

The Blind-Spot Collision Warning (BCW) system uses radar sensors in the rear bumper to monitor and warn the driver of an approaching vehicle in the driver's blind spot area. The system monitors the rear area of the vehicle and provides information to the driver with an audible alert and a i ...