Kia Stinger: Power Tailgate System / Power Tailgate Spindle

Kia Stinger CK 2018-2024 Service Manual / Body Electrical System / Power Tailgate System / Power Tailgate Spindle

Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the rear pillar trim. (Refer to Body - "Rear Pillar Trim")

3.	Disconnect the power tailgate spindle connector (A).

4.	Using a screwdriver, lift the socket clips (A) up slightly.

Remove the power tailgate spindle assembly (B).

•	Work in a group of two or more when removing and installing the PTG spindle.

•	Take care not to close the tail gate while the PTG spindle is being removed.

•	Do not reuse the PTG spindle drive if it is dropped on the ground. Discard any dropped PTG spindles.

•	When carefully removing the socket clip, take extra care not to lose the socket clip as it may pop out.

•	When carefully removing the socket clip, take care not to scratch the clip surface as scratches may cause corrosions in the future.

Installation

1.	Install the power tailgate spindle assembly.

2.	Connect the power tailgate spindle connector.

3.	Install the rear pillar trim.

Connect the negative (-) battery terminal.

•	When assembling the PTG spindle drive to the ball socket, listen for a 'click' sound to make sure that it is firmly assembled.

•	After assembling the PTG Spindle drive to the ball socket, check the socket clip if it is firmly assembled or not. (the clip should not protrude from the socket.)

•	After assembling the PTG Spindle drive, make sure that the grommet on the body side is firmly assembled.

Inspection

Inspection of the PTG Spindle

Refer to Power Tailgate System - "Troubleshooting"

Anti-Pinch Strip

Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the tailgate trim. (Refer to Body - "Tailgate Trim" ...

Power Windows

Components and components location Component Location 1. Driver power window switch 2. Assist power window switch 3. Rear power window switch 4. Front win ...

Other information:

Kia Stinger CK 2018-2024 Service Manual: Fuel Line

Repair procedures Removal Low Pressure Fuel Line [Engine Room <-> Extension Fuel Line] 1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2. Switc ...

Kia Stinger CK 2018-2024 Service Manual: Seat Belt Buckle Switch (BS)

Description and operation Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The seat belt buckle circuit operates from internal boost ...