Kia Stinger: Evaporative Emission Control System / Purge Control Solenoid Valve (PCSV)

Kia Stinger CK 2018-2024 Service Manual / Emission Control System / Evaporative Emission Control System / Purge Control Solenoid Valve (PCSV)

Specifications

Specification

Item	Specification
Coil Resistance (Ω)	18.5 - 22.5 [20°C(68°F)]

Description and operation

Description

Installed on the surge tank, the Purge Control Solenoid Valve (PCSV) controls the passage between the canister and the intake manifold. This solenoid valve is open when the ECM grounds the valve control line. When the passage is open (PCSV ON), fuel vapor stored in the canister is transferred to the intake manifold.

Schematic diagrams

Circuit Diagram

Harness Connector

Repair procedures

Inspection

1.	Switch "OFF" the ignition.

2.	Disconnect the PCSV connector.

3.	Measure resistance between the PCSV terminals 1 and 2.

Check that the resistance is within the specification.

Specification: 22.0 - 26.0 Ω [20°C(68°F)]

Removal

1.	Switch "OFF" the ignition and disconnect the negative (-) battery terminal.

2.	Remove the engine cover. (Refer to Engine Mechanical System - "Engine Cover")

3.	Disconnect the purge control solenoid valve connector (A).

4.	Disconnect the vapor hoses (B) from the purge control solenoid valve.

Installation

•	Install the component to the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Take caution to keep foreign materials out of the valve.

1.	Install in the reverse order of removal.

Canister

Repair procedures Removal 1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal. 2. Remove the rear-left wheel &am ...

Fuel Filler Cap

Description and operation Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the ...

Other information:

Kia Stinger CK 2018-2024 Service Manual: Integrated Body Control Unit (IBU)

Specifications Specifications Items Specifications Rated voltage DC 12 V Operating voltage DC 9 - 16 V Operating temperature -40 - 176°F (-40 - 80°C) D ...

Kia Stinger CK 2018-2024 Service Manual: Rear Lower Arm

Repair procedures Removal 1. Remove wheel nuts, wheel and tire (A) from hub. Tightening torque: 107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft) ...