Kia Stinger: Engine Control System / Rail Pressure Sensor (RPS)
Specifications
| Specification |
|
Pressure |
Output Voltage (V) [Vref=5V] |
|
|
bar |
[MPa (kgf/cm², psi)] |
|
|
0 |
0 (0, 0) |
0.5 |
|
140 |
14 (142, 2031) |
2.5 |
|
280 |
28 (286, 4061) |
4.5 |
Description and operation
| Description |
Installed on the delivery pipe, the Rail Pressure Sensor (RPS) measures the instantaneous fuel pressure in the delivery pipe. The sensing element (semiconductor element) built into the sensor converts the pressure to voltage signal. By using this signal, the ECM controls the correct injection amount and timing and adjusts the fuel pressure with the fuel pressure regulator valve if the actual pressure calculated by the RPS output signal is different from the target pressure.
Schematic diagrams
| Circuit Diagram |
| Harness Connector |
Repair procedures
| Inspection |
| 1. |
Connect the KDS on the Data Link Connector (DLC). |
| 2. |
Measure the output voltage and fuel pressure of the RPS at idle and various engine speed.
|
||||||||||||||
| Removal |
| 1. |
Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - "Release Residual Pressure in Fuel Line") |
| 2. |
Switch "OFF" the ignition and disconnect the negative (-) battery terminal. |
| 3. |
Remove the intake manifold. (Refer to Engine Mechanical System - “Intake Manifold”) |
| 4. |
Remove the delivery pipe foam (A).
|
| 5. |
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.
|
| Installation |
|
| 1. |
Install in the reverse order of removal. |
Troubleshooting
| Signal Waveform |
Exhaust Gas Temperature Sensor (EGTS)
Specifications
Specification
Exhaust Gas Temperature
Sensor (EGTS) #1, 2
▷ Type : Thermistor type
Temperature [°C (°F)]
Resistance (kΩ)
...
CVVT Oil Temperature Sensor (OTS)
Specifications
Specification
Temperature [°C (°F)]
Resistance (kΩ)
-40
52.15
-20
28.82
...
Other information:
Kia Stinger CK 2018-2024 Service Manual: Air Cleaner Filter
Repair procedures Inspection 1. Remove the air cleaner element. 2. Check that the air filter is excessively dirty. If the air filter is excessively dirty, replace the air cleaner element. 3. If the air cleaner el ...
Kia Stinger CK 2018-2024 Service Manual: Smart Cruise Control (Stop & Go) (SCC) ECU
Description and operation Description The smart cruise control unit is installed on the front right-hand side of the chassis. A radar sensor is embedded in the front section of the unit. This sensor detects vehicles and objects in front of the vehicle. The radar sensor can detect ...
