Kia Stinger: Rear Suspension System / Rear Assist Arm
Repair procedures
| 1. |
Remove wheel nuts, wheel and tire (A) from hub.
|
Tightening torque:
107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)
|
|
Be careful not to damage the wheel bolts when removing the wheel
and tire (A).
|
|
| 2. |
Loosen the bolt (A) and then separate the rear assist arm from the rear
axle.
|
Tightening torque:
117.7 - 132.4 N·m (12.0 - 13.5 kgf·m, 86.8 - 97.6 lb·ft)
|
|
Up the transmission jack under the lower arm in order to remove
the rear assist arm in no-load condition.
|
|
| 3. |
Loosen the bolt & nut and then remove the rear assist arm from the rear
cross member.
|
Tightening torque :
137.3 - 156.9 N·m (14.0 - 16.0 kgf·m, 101.3 - 115.7 lb·ft)
|
|
| 4. |
Install in the reverse order of removal.
|
Install at the empty vehicle height when it is assembled.
|
|
| 5. |
Check the alignment.
(Refer to Suspension System - "Alignment")
|
| 1. |
Check the bushing for wear and deterioration.
|
| 2. |
Check for all bolts and nuts.
|
Repair procedures
Removal
[Rear upper arm rear]
1.
Remove wheel nuts, wheel and tire (A) from hub.
Tightening torque:
107.9 - 127.5 N·m (11.0 - ...
Repair procedures
Removal
1.
Remove wheel nuts, wheel and tire (A) from hub.
Tightening torque:
107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94. ...
Other information:
Repair procedures
Replacement
•
Special grease must be applied to the driveshaft joint. Do not
substitute with another type of grease.
•
The ...
The smart ventilation system maintains pleasant/fresh air condition inside the
passenger compartment by automatically detecting/controlling the temperature and
humidity when you drive the vehicle with the climate control system in the OFF position.
When the smart ventilation system starts to o ...
Rear Upper Arm
Rear Lower Arm