Kia Stinger: Rear Bumper / Rear Bumper Beam Assembly

Kia Stinger CK 2018-2024 Service Manual / Front Seat Belt / Rear Bumper / Rear Bumper Beam Assembly

Components and components location

Component Location

1. Rear bumper beam assembly

Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the rear bumper cover. (Refer to Rear Bumper - "Rear Bumper Assembly")

2.	Disconnect the rear bumper beam mounting wiring harness.

3.	Remove the mounting clips (A), then remove the rear bumper beam assembly (B).

Install in the reverse order of removal.

•	Make sure that the connector is connected properly.

•	Replace any damage clips.

Rear Bumper Assembly

Components and components location Component Location 1. Rear bumper cover Repair procedures Replacement ...

Rear Door

Components and components location Components 1. Rear door trim panel 2. Rear door module 3. Rear door panel 4. Rear door fixed glass & weatherstrip 5. ...

Other information:

Kia Stinger CK 2018-2024 Owners Manual: Winter driving

Severe weather conditions in the winter result in greater wear and other problems. To minimize the problems of winter driving, you should follow these suggestions: WARNING - Driving with summer tires Summer tires are equipped to provide the best driving performance on dry roads, varying accord ...

Kia Stinger CK 2018-2024 Service Manual: Roof Trim Assembly

Components and components location Component Location 1. Roof Trim Assembly Repair procedures Replacement Put on gloves to protect your hands. ...