Kia Stinger: Rear Door / Rear Door Window Glass

Kia Stinger CK 2018-2024 Service Manual / Front Seat Belt / Rear Door / Rear Door Window Glass

Components and components location

Component Location

1. Rear door window glass

Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim")

2.	Remove the rear door frame inner cover (A) by using a remover.

3.	Remove the rear door belt inside weatherstrip (A).

4.	Remove the rear door belt outside weatherstrip (A) by using a remover.

5.	Remove the rear door drive channel (A) after loosening the mounting screws.

6.	Remove the rear door frame molding (A) by using a remover.

7.	Remove the rear door frame garnish (A) and glass run.

8.	Remove the rear door window glass mounting hole plug (A).

Loosen the mounting bolt, and pull out the rear door window glass (B) by tilting it sideways.

Tightening torque :

7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)

Be careful not to drop the glass and/or scratch the glass surface.

•	Use the door switch to align the mounting hole/bolt with the hole in the door.

•	If the window motor cannot be operated, remove the motor and align the hole by hand.

10.

Install in the reverse order of removal.

•	Roll the glass up and down to see if it moves freely without binding.

•	Adjust glass position as needed.

•	Make sure that the door locks and opens properly.

•	Replace any damaged clips.

Rear Door Inside Handle

Repair procedures Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Rremove the rear door inside h ...

Rear Door Module

Components and components location Component Location 1. Rear door module Repair procedures Replacement ...

Other information:

Kia Stinger CK 2018-2024 Service Manual: Smart Cruise Control (Stop & Go) (SCC) ECU

Description and operation Description The smart cruise control unit is installed on the front right-hand side of the chassis. A radar sensor is embedded in the front section of the unit. This sensor detects vehicles and objects in front of the vehicle. The radar sensor can detect ...

Kia Stinger CK 2018-2024 Owners Manual: Emergency starting

Connect cables in numerical order and disconnect in reverse order. Jump starting Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm to yourself or damage to your vehicle or battery, follow these jump starting procedures. If in doubt, we strongly recommend that you h ...