Kia Stinger: Rear Seat / Rear Seat Assembly
Components and components location
1. Rear seat cushion assembly
2. Rear back side seat assembly [LH]
|
3. Rear seat back assembly
4. Rear back side seat assembly [RH]
|
Repair procedures
Put on gloves to protect your hands.
|
• |
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
• |
Take care not to bend or scratch the trim and panels.
|
|
1. |
Separate the rear seat cushion assembly (A).
|
2. |
Remove the rear seat cushion assembly after disconnecting the rear seat
heater connector (A).
|
3. |
Remove the rear back side seat (A) by pulling it up after loosening the
mounting bolts.
|
4. |
Disconnect the rear center seat belt (A) after pressing the groove in
the direction of the arrow.
|
5. |
Fold the rear seat back assembly (A).
|
6. |
Open the hinge bracket cap (A) after loosening the mounting bolt.
|
7. |
Remove the rear seat back assembly (A).
|
8. |
Install in the reverse order of removal.
•
|
Make sure that the connector is connected properly.
|
•
|
Replace any damage clips.
|
|
|
Components and components location
Components
1. Rear seat cushion pad
2. Rear seat cushion heater
3. Rear seat cushion covering
4. Rear seat back covering
5 ...
Components and components location
Component Location
1. Rear back side seat assembly
[LH]
2. Rear seat back assembly [LH]
3. Rear seat back assembly [RH]
...
Other information:
Description and operation
Description
•
The front impact sensor (FIS) is installed in the Front End Module (FEM).
•
FIS is a remote sensor that detects acceleration due to a collision at
its mounting location.
•
...
Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
3.
Disconnect the power tailgate latch connector (A) and power closing u ...