Kia Stinger: Body Side Molding / Rear Spoiler

Kia Stinger CK 2018-2024 Service Manual / Body (Interior and Exterior) / Body Side Molding / Rear Spoiler

Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the tail gate trim. (Refer to Tail Gate - "Tail Gate Trim")

2.	Remove the tail gate lever bumper (A) after loosening the mounting screw.

Loosen the rear spoiler mounting nuts.

Tightening torque :

5.9 - 6.4 N·m (0.6 - 0.65 Kgf·m, 4.3 - 4.7 lb·ft)

4.	Remove the rear spoiler (A).

Install in the reverse order of removal.

Replace any damaged clips.

Fender Garnish

Repair procedures Replacement Put on gloves to protect your hands. &nbs ...

Pillar Garnish

Repair procedures Replacement • Use a plastic panel removal tool to remove interior trim pi ...

Other information:

Kia Stinger CK 2018-2024 Owners Manual: Automatic transmission operation

The automatic transmission has 8 forward speeds and one reverse speed. The individual speeds are selected automatically, depending on the position of the shift lever. ✽ NOTICE The first few shifts on a new vehicle, if the battery has been disconnected, may be somewhat abrupt. This is a norma ...

Kia Stinger CK 2018-2024 Owners Manual: If the engine will not start

If engine doesn't turn over or turns over slowly 1. Be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set. 2. Check the battery connections to be sure they are clean and tight. 3. Turn on the interior light. If the light dims or goes out when you operate the sta ...