Kia Stinger: Lighting System / Room Lamp

Kia Stinger CK 2018-2024 Service Manual / Body Electrical System / Lighting System / Room Lamp

Repair procedures
Removal
  

Put on gloves to prevent hand injuries.

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

1.

Disconnect the negative (-) battery terminal.

2.

Using a screwdriver or remover, separate the room lamp (A) from the room lamp.

3.

Remove the room lamp (A) after loosening the mounting screws.

  

When removing the room lamp, be careful of the direction in which the tool is inserted (B).

When inserting the tool in the opposite direction, take caution as the room lamp may be damaged.

4.

Remove the room lamp assembly after disconnecting the room lamp connector (A).

Installation
1.

Connect the room lamp connector.

2.

Install the room lamp.

3.

Install the room lamp lens.

4.

Connect the negative (-) battery terminal.

Turn Signal Lamp
Repair procedures Removal Door Mirror Turn Signal Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the outside rear view ...

Luggage Room Lamp
Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, separate the luggage room lamp (A). ...

Other information:

Kia Stinger CK 2018-2024 Service Manual: Timing Chain Cover


Repair procedures Removal    In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do ...

Kia Stinger CK 2018-2024 Service Manual: Low Pressure Fuel Pump


Repair procedures Inspection [Fuel sender] 1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal. 2. Remove the fuel pump assembly. 3. Using an ohmmeter, measure the resistance between term ...

Copyright © www.kstinger.com 2015-2024