Kia Stinger: SRSCM / Seat Belt Buckle Switch (BS)

Kia Stinger CK 2018-2024 Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS)

Description and operation
Description

The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The seat belt buckle circuit operates from internal boost voltage supplied by the SRSCM, and uses chassis ground for the signal return. The buckle status shall modify the SRSCM deployment. If the seat belt is unbuckled, the corresponding pretensioner will not be deactivated.

Components and components location
Components

1. Seat Belt Buckle Switch (BS)


Repair procedures
Removal
1.

1. Disconnect the negative battery terminal, and wait for at least three minutes before beginning to work.

2.

Remove the front seat assembly.

(Refer to the Body - "Front Seat Assembly")

3.

Loosen the mouting bolt and then remove the seat belt buckle switch.

Installation
1.

Disconnect the negative battery terminal, and wait for at least three minutes before beginning to work.

2.

Install in the reverse order of removal.

3.

Reconnect the negative battery terminal.

4.

After installing the seat belt buckle switch, confirm proper system operation:

• Switch "ON" the ignition. The SRS indicator light should turn on for about six seconds and then off.

Side Impact Sensor (SIS)
Description and operation Description • Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensor (P-SIS) installed at each center of the front doo ...

Airbag Module
...

Other information:

Kia Stinger CK 2018-2024 Service Manual: Crash Pad Lower Panel


Components and components location Component Location 1. Crash pad lower panel Repair procedures Replacement    Put on gloves to protect your hands. ...

Kia Stinger CK 2018-2024 Owners Manual: Tire sidewall labeling


This information identifies and describes the fundamental characteristics of the tire and also provides the tire identification number (TIN) for safety standard certification. The TIN can be used to identify the tire in case of a recall. 1. Manufacturer or brand name Manufacturer or Brand na ...

Copyright © www.kstinger.com 2015-2024