Kia Stinger: Airbag Module / Side Airbag (SAB) Module
Description and operation
Installed inside the front seat, the side airbags (SAB) protect the driver and
front passenger from danger in the event of a side crash. The SRSCM determines deployment
of side airbag based on Side Impact Sensor (SIS) signal.
|
Never attempt to measure the circuit resistance of the airbag module
(squib) even if you are using the specified tester. If the circuit resistance
is measured with a tester, accidental airbag deployment will result in serious
personal injury
|
Components and components location
Repair procedures
| 1. |
Disconnect the battery negative terminal.
|
After disconnecting the cables, wait at least 30 seconds.
|
|
| 2. |
Remove the seat back cover.
(Refer to Body -"Front seat back cover")
|
Improper mounting of the front seat back cover, so interfering
with the normal deployment of side airbags and front seat backrest
ensure that the cover is well seated.
|
|
| 3. |
Loosen the side airbag module nuts and then remove the airbag module
(A).
|
Tightening torque :
6.0 - 8.0 N.m (0.6 - 0.8 kgf.m, 4.4 - 5.9 lb-ft)
|
|
| 4. |
Install in the reverse order of removal.
|
Description and operation
Description
Installed inside the crash pad, the passenger airbag (PAB) protects the front
passenger in the event of a frontal crash. The SRSCM determines if a ...
Description and operation
Description
Installed inside the headliner, the curtain airbags (CAB) protect the driver
and passengers from danger in the eThe SRSCM determines deployment of ...
Other information:
Components and components location
Component Location
1. Rear seat belt retractor [LH]
2. Rear seat belt retractor [RH]
Repair procedures
Replacement
When instal ...
Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, separate the luggage room lamp (A).
3.
Disconnect the luggage room lamp connector (A).
...
Passenger Airbag (PAB) Module
Curtain Airbag (CAB) Module