Kia Stinger: Smart Cruise Control (Stop & Go) System / Smart Cruise Control (Stop & Go) (SCC) Switch

Kia Stinger CK 2018-2024 Service Manual / Engine Electrical System / Smart Cruise Control (Stop & Go) System / Smart Cruise Control (Stop & Go) (SCC) Switch

Components and components location
Components

1. Left Remote Control Switch
(Audio + Bluetooth + Voice)
2. Right Remote Control Switch
(Trip Computer + ACC + SCC)

Schematic diagrams
Circuit Diagram

[Audio + Bluetooth + Voice]

[Trip + ACC]

[Trip + ACC + SCC]

Repair procedures
Inspection
1.

Check for resistance between terminals in each switch position (RH).

[RH : Trip + ACC + SCC]

Switch
Connector
terminal
Resistance
(±3%)
Cancel
2-6
390 Ω
SET -
610 Ω
RES +
910 Ω
Cruise ON/OFF
1.38 kΩ
Cruise & Speed Limit ON/OFF
2.13 kΩ
SCC (Following distance control)
3.63 kΩ
Group
1-6
390 Ω
Trip Up
610 Ω
Trip Down
910 Ω
ENTER
1.38 kΩ

Removal
1.

Disconnect the negative (-) battery terminal.

2.

Remove the steering wheel assembly.

(Refer to Steering System - "Steering Wheel")

3.

Remove the paddle shift switch (A) after loosening the mounting screws.

[LH]

[RH]

4.

Disconnect the paddle shift switch connector (A).

[LH]

[RH]

5.

Remove the steering front cover (A) after loosening the mounting screws.

6.

Remove the steering rear cover (A) after loosening the mounting screws.

7.

Remove the steering back cover (A) after loosening the mounting screws.

8.

Disconnect the steering wheel remote control connector (A).

[LH]

[RH]

9.

Remove the steering wheel remote control (A) after loosening the mounting screws.

[LH]

[RH]

Installation
1.

Install the steering wheel remote control.

2.

Connect the steering remote control connector.

3.

Install the steering back cover.

4.

Install the steering rear cover.

5.

Install the steering front cover.

6.

Connect the paddle shift switch connector.

7.

Install the paddle shift switch.

8.

Install the steering wheel assembly.

9.

Connect the negative (-) battery terminal.

Smart Cruise Control (Stop & Go) (SCC) Unit-Radar
Specifications Specification Item Specification Power supply(V) 12 Operation voltage (V) 9 - 16 ...

Smart Cruise Control (Stop & Go) (SCC) ECU
Description and operation Description The smart cruise control unit is installed on the front right-hand side of the chassis. A radar sensor is embedded in the front section of the uni ...

Other information:

Kia Stinger CK 2018-2024 Owners Manual: Sliding the sunroof


When the sunshade is closed Pull the sunroof control lever backward to the 2nd detent position, and both the sunshade and sunroof glass will slide all the way open. When the sunshade is opened Pull the sunroof control lever back ward to the 1st or 2nd detent position, the sunroof glass will ...

Kia Stinger CK 2018-2024 Service Manual: Front Door Module


Components and components location Component Location 1. Front door module Repair procedures Front Door Module    Put on gloves to protect your hands. ...

Copyright © www.kstinger.com 2015-2024