Kia Stinger: Electric Power Steering / Steering Gear box

Kia Stinger CK 2018-2024 Service Manual / Steering System / Electric Power Steering / Steering Gear box

Components and components location

Components

1. Tie rod end

2. R-MDPS motor

Repair procedures

Removal

Remove wheel nuts, front wheel and tire (A) from hub.

Tightening torque :

107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)

Be careful not to damage the wheel bolts when removing the wheel and tire (A).

Loosen the bolt (A) and then separate the universal joint from the shaft joint.

Tightening torque :

32.4 - 37.3 N·m (3.3 - 3.8 kgf·m, 23.9 - 27.5 lb·ft)

[LHD]

[RHD]

•	Keep the steering wheel in a neutral position. Moving the steering wheel may damage the cable inside the clock spring.

•	Tighten the steering column bolts in the same direction as they were removed.

•	Do not reuse the universal joint bolt when installing.

3.	Disconnect the R-MDPS connector (A) and clip (B). [LHD] [RHD]

4.	Disconnect the R-MDPS wiring clip (A) from the sub frame.

Remove the tie rod end nut.

Tightening Torques :

88.3 - 107.9 N·m (9.0 - 11.0 kgf·m, 65.1 - 79.6 lb·ft)

6.	Remove the knuckle by using the ball joint remover (A).

Loosen the gear box bolts (A) and then remove the gear box.

[LHD]

[RHD]

Must use a engine jack for safety.

Loosen the shaft joint bolt (A) from the gear box.

Tightening Torques :

32.4 - 37.3 N·m (3.3 - 3.8 kgf·m, 23.9 - 27.5 lb·ft)

9.	Check the front alignment. (Refer to Suspension System - "Alignment")

10.	Install in the reverse order of removal.

11.	Register "ASP calibration EPS type recognition" by GDS after replacing steering column assembly. (Refer to Electric Power Steering - "Repair procedures")

Steering Column and Shaft

Repair procedures Replacement [LHD] 1. Disconnect the battery negative cable. 2. Turn the steering wheel so that the front wheels are facing strai ...

Steering Column & Shaft

Components and components location Components 1. Steering column module (SCM) 2. Steering column module (SCM) bracket Specifications Spec ...

Other information:

Kia Stinger CK 2018-2024 Service Manual: Front Differential Carrier

Repair procedures Removal 1. Remove the propeller shaft. (Refer to Driveshaft and axle - "Front propeller shaft") 2. Remove the sub frame. (Refer to Suspension System - "Sub frame") 3. Separate th ...

Kia Stinger CK 2018-2024 Service Manual: Power Tailgate Module

Components and components location Components No. Connector A Connector B Connector C 1 Power supply Cinching motor (+) Spindle motor (RH)_Close (-) 2 ...