Kia Stinger: Tire Pressure Monitoring System / TPMS Receiver

Kia Stinger CK 2018-2024 Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Receiver

Description and operation

Operation

General Function

•	Auto-learn takes place only once per Ignition cycle.

•	On successful completion, 4 road wheel sensor ID's are latched into memory for monitoring.

•	Until Auto-learn completes, previously learned sensors are monitored for under inflation / leak warnings.

General Conditions to Learn New Sensors:

•	Receiver must determine that it is confident that sensor is not temporary:

a.	Uses vehicle speed.

b.	Uses confidence reduction of previously learned sensors.

•	Typical time at driving continuously over 15.5 mph(25 kph) to learn a new sensor is up to 20 minutes.

General Conditions to Un-Learn a sensor that is removed :

•	It takes less than 20 minutes at 15.5 mph(20~30 kph).

•	Confidence reduction is dependent on time which vehicle is driven at speed greater than or equal to 12.4 mph(20~30 kph).

Repair procedures

Removal

1.	Turn ignition switch OFF and disconnect the negative (-) battery cable.

2.	Remove the glove box housing. (Refer to Body - "Glove box housing")

3.	Disconnect the blower motor connector (A) & fix clip (B).

4.	Disconnect the integrated body control unit (IBU) connector (A).

5.	Loosen the nut & bolt and then remove the integrated body control unit (IBU) (A).

6.	Disconnect the wiring hannes fix clip (A) from the integrated body control unit (IBU).

Diagnosis procedure by using diagnostic device

The main contents of diagnostic method using diagnostic device are as follows:

1.	Connect self-diagnosis connector (16 pins) located in the lower driver side crash pad to self-diagnosis device, and then turn on the self-diagnosis device after key is ON.

2.	Select the "vehicle model" and "TPMS" on KDS vehicle selection screen, then select OK.

[Vehicle Name Writing Method]

[Wheel Sensor ID Writing Method]

TPMS Sensor

Description and operation Description 1. Function • By detecting the pressure, temperature, acceleration, and battery condition, tra ...

Steering System

Repair procedures Service Adjustment Procedure Steering Wheel Play Inspection 1. Turn the steering wheel so that the front wheels are facing straight ahead. ...

Other information:

Kia Stinger CK 2018-2024 Owners Manual: Launch Control

Launch Control Operation When using Launch Control, a driver should always make sure that the engine’s cooling water is warmed up and reaches a recommended temperature. To operate ESC Off state 2, Press and hold ESC button for more than 3 seconds in Sports mode. (Status Display on Clus ...

Kia Stinger CK 2018-2024 Owners Manual: How to deactivate the Smart

Liftgate function using the smart key 1. Door lock 2. Door unlock 3. Liftgate open 4. Panic If you press any button of the smart key during the Detect and Alert stage, the Smart Liftgate function will be deactivated. Make sure to be aware of how to deactivate the Smart Liftgate function fo ...